Open Barrel Splice

$0.34$0.36

Open barrel crimp splice with serrations made from brass with a tin plating. This open barrel crimp splice is suitable for use in applications where wire splicing is required. Made in USA

Description

Open barrel crimp splice with serrations made from brass with a tin plating. This open barrel crimp splice is suitable for use in applications where splicing is required.

All Crimps are genuine TE brand. Made in USA.

CMA = Circular Mil Area

For best results use with Knipex Crimping Pliers 

Sizes Available

X-Small 400-1500 CMA
Small 1500-5000 CMA
Medium 4000-9000 CMA
Large 7000-13000 CMA

Common wire sizes CMA

Add together to get total CMA to choose correct size splice (eg 16ga + 20ga + 20ga + 20ga = 2575CMA + 1006CMA +1006CMA +1006CMA = 5593CMA = Medium Splice)

AWG Area (mm²) CMA
24 0.205 404
20 0.51 1006
18 0.79 1559
16 1.305 2575

Crimped Splice Requirements:
The illustration below shows the crimp features required for typical pigtail and thru type splices after termination.
A. Crimp Length
For optimum crimp length effectiveness, the crimp must be within the area shown and must meet the
crimp dimensions provided. Effective crimp length shall be defined as that portion of the splice,
excluding tapers, fully formed by the crimping tool.
B. Crimp Tapers
Top and bottom crimp tapers shall conform to the dimensions given in Figure 3. Crimp tapers contribute to
crimp effectiveness and reduce the risk of nicked and/or broken conductor strands due to sharp material
edges at the ends of the splice.
C. Cutoff Tabs
Cutoff tabs shall not exceed the dimension shown in View A.
D. Cutoff Burrs
Cutoff burrs shall not exceed the dimension shown in View A.
E. Wire Barrel Flash
Wire barrel flash, which can be caused by incorrect set up and/or worn and broken crimp tooling, shall not
exceed the dimension shown in Section X-X.
F. Conductor Extension
Conductors must extend completely through the splice. Excess magnet wire and lead wire strands will be
trimmed off by the application equipment as shown.
G. Splice Seam
The splice seam must be closed with no evidence of loose wire strands visible in the seam as shown in
Figure 3. Single wire strand exposure may occur in seam beyond effective crimp length. See Figure 3.
H. Tensile Strength
Crimp quality shall be judged solely on proper crimp width, crimp height, and conformance to the
requirements shown. When crimped as specified, crimp tensile strength will be approximately 70% off the tensile strength of the smallest wire in the splice.

 

Additional information

Weight 0.2 kg
Dimensions 4 × 4 × 4 cm
Size

X-Small, Small, Medium, Large

Reviews

There are no reviews yet.

Be the first to review “Open Barrel Splice”

Your email address will not be published. Required fields are marked *

You may also like…

  • Open Barrell Splice Kit

    Open Barrel Splice Kit – 100pcs

    $36.00
    Add to cart